Steps in Creating PPPoE Dialer using Windows 7

In this guide will show you how the steps on creating a PPPoE dialer in Windows 7.

Step 1: Click the start menu icon Windows 7 Orb at the left bottom section of your Desktop as shown as the figure below.

Step 2: Click on the Control Panel option.

Step 3: Then click the Network and Internet section.

Steps 4: Click Network and Sharing Center.

Steps 5: Under ‘Change your networking settings’, select Set up a new connection or network.

Steps 6: Select Connect to the Internet and click Next.

Steps 7: Click the Broadband (PPPoE) option.

Steps 8: Type your username.

Steps 9: Type your password (very case sensitive). Tick ‘Show Characters’ only if you want to look at the password you have typed or you are going to type. Not recommended if you care for your privacy; Tick ‘Remember Password’ if you don’t want to type your password once you connect to the Internet. In “Internet Account Information”, enter the information for your account:

• Username: Enter your username, e.g. 6047366500@pppoe.net
• Password: Enter your password e.g. V6H1E5
• Confirm password: Enter your password again
• Allow other people to use this connection (Optional)

Steps 10: Type the name of your internet provider. If not, Windows will name it Broadband Connection and you can rename it anytime. (Illustration above)

Steps 11: If you want to allow anyone who has access to the computer to use the internet connection, tick ‘Allow other people to use this connection’. (Illustration on #9)

Steps 12: Click Connect. (Illustration on #9)

Steps 13: Click Close and you’re done.